LAN Film Fill is widely used in counter flow cooling towers, the product is a cellular block after bonding molding, according to the interval size of the tower bracket, cut into different sizes. Easy to installation. High heat exchange efficiency, small wind resistance, no-easy plugged. PVC, PP material are both available. Customers can choose according to cooling media temperature.
.Features
■ Advanced technology, reasonable design, with good cooling effect.
■ Good ventilation, small resistance, strong hydrophilic, large contact area, and good film-forming, easy packing, good heat conductivity, good chemical stability, acid, alkali and organic solvent corrosion, etc.
■ The staggered ring material form assembling, packing general is 60 ° Angle, polyvinyl chloride (PVC), polypropylene (PP) two kinds of packing material available.
Properties
With different request in LAN film fill, like length and width, materials or thickness, etc, please inform us your detailed request to get correct solution and offer. Newin could cover all customer requirements. Fill media in flame retardant or anti-bacterial execution are also available on request.
| Module Length (Max) |
mm |
3660 |
| Module Width |
mm |
305/610 |
| Module Depth |
mm |
— |
| Flute Height |
mm |
19/30 |
| Flute Corrugation Angle |
degrees |
－ |
| Surface Area |
m2/m3 |
150 |
| Sheet Thickness - Before Forming |
mm |
0.32 |
| Sheet Thickness - After Forming |
mm |
0.28 |
| Max. application temp. (short time) - PVC |
°C |
60 |
| Max.operating temp. (short time) - High temp. |
°C |
80 |
| Customized size and thickness available for special request. Contact Newin for details. |
Structure & Installation Drawing
Newin supply structure & installtion drawing advice with jobsite storage advice and quality control report along with shipment to make attention to customers when they receive the materals. OEM or special mold design also available on request.
Application & Usage
Newin LAN counter flow film fill is applicable for other brands counter flow cooling tower series of LDCM, LDC, LDC-EPC, LNCM etc., with SGS test to keep high quality infill to get the high efficiency of the cooling tower. Inform us the tower model or size, we will estimate the Nos of sheets needed for your cooling tower replacing.
Applicable Commercial StandardsSheets material is strictly followed below SGS test with ASTM standards. Each property or all properties as below tested by your products are also vailable on request.
| Property |
Test Method |
Values |
| Specific Gravity |
ASTM D792-13
Method B |
1.426g/cm3 |
| Oxygen Index |
ASTM D2863-13 |
34.50% |
| Tear Strength |
ASTM D1004-13 |
X direction |
111 N |
| Y direction |
121 N |
| Tensible Test |
ASTM D 882-12 |
Tensile Strength |
X direction |
51.1 MPa |
| Y direction |
45.3 Mpa |
Elongation at
Break |
X direction |
87% |
| Y direction |
56% |
| Values shown above based on SGS Test No.: GZIN1708039662PS by Newin |
Statements and methods presented are based upon the best available information and practices
known to Newin. Conditions of use may vary and are beyond control, the user should undertake
sufficient tests to determine the suitability for any intended use of the material. |
Filed Data for Counter Flow Film Fill Replacement
Fill in below measurements data for your maintenance cooling tower or reparing projects demand quality and reliability, count on Newin, site visit or maintenance service, engineered to fit the cooling tower fills or components.
